knowledge and contact support tractus3d
operating-the-3d-printer , using-the-3d-printer

Removing a print from the print bed

NOTE: Always let the print bed cool down to room temperature before removing the print. Otherwise you can damage the bed!

NOTE: When you print a product with a brim, be aware of the danger of cutting yourself when removing the print from the build plate. A brim can be very sharp!

LARGE VOLUME series 3D Printer
PRO series 3D printer
DESK series 3D printer

LARGE VOLUME series

Once your 3D print is finished it must be removed from the build plate. There are several methods to remove the printed object from the bed on room temperature.

After cooldown is completed, just remove the loosened prints from the bed.

Use a spatula under the edge of a print, keep the spatula always as flat as possible parallel with the bed to avoid scratches or damage to the bed. Apply a little amount of force to remove
the print of the bed.

Still stuck? Try some handwarm water around the model and leave it for a few minutes.

PRO series

Once your 3D print is finished it must be removed from the build plate. There are several methods to remove the printed object from the bed on room temperature.

After cooldown is completed, just remove the loosened prints from the bed.

Use a spatula under the edge of a print, keep the spatula always as flat as possible parallel with the bed to avoid scratches or damage to the bed. Apply a little amount of force to remove the print of the bed.

Still stuck? Carefully remove the bed from the 3D printer and try some cold water around the bed and model. Or place the bed in the refrigerator for some minutes. Let the bed settle back to room temperature before placing it back in the 3D printer. See chapter in Maintenance > Changing bed plate

DESK series

Once your 3D print is finished it must be removed from the build plate. There are several methods to remove the printed object from the bed on room temperature.

After cooldown is completed, just remove the loosened prints from the bed.

Use a spatula under the edge of a print, keep the spatula always as flat as possible parallel with the bed to avoid scratches or damage to the bed. Apply a little amount of force to remove the print of the bed.

Gently tap the model with your hand/fist and see if the print will pop loose.

Still stuck? Carefully remove the bed from the 3D printer and try some cold water around the bed and model. Or place the bed in the refrigerator for some minutes. Let the bed settle back to room temperature before placing it back in the 3D printer. See chapter in Maintenance > Changing bed plate