knowledge and contact support tractus3d
operating-the-3d-printer , post-processing-techniques , using-the-3d-printer , post-processing

Remove support material or brim

NOTE: It is advised to wear protective gloves when the support structure contains sharp corners or half broken parts.

Prints which are using (breakaway) support will require post-processing to remove the support structures. You can manually break the support structures from the model you printed. It will require sometimes a tool like pliers or tweezers to break away the support material.

After removing most of the support structure, the remaining part(s) of the support structure can be pulled from
the model with cutting pliers. Carefully get underneath it and then bend it upwards.

Sometimes a final layer of the support material remains after pulling the support from the model. Try pulling
this off with pliers or with tweezers for smaller parts.