operating-the-3d-printer , using-the-3d-printer

Preparing the print bed

LARGE VOLUME series 3D Printer

PRO series 3D printer

DESK series 3D printer

LARGE VOLUME series

We recommend you clean the plate with a spatula if printing remains are there.

After this, clean the plate with some hand warm water and a towel. In case of some remaining grease, use some Isopropanol. Make sure the bed is completely cleaned and don’t touch the plate after cleaning.

We recommend using an adhesion product like spray (3DLac) or hairspray (make sure it’s sticky). In some cases, using glue sticks (Elmer’s Washable School Glue) will work great too. Make sure you not to use too much of the adhesion product as this will make the adhesion to the bed worse.

PRO series

We recommend you clean the plate with a spatula if printing remains are there.

After this, clean the plate with some hand warm water and a towel. In case of some remaining grease, use some Isopropanol. Make sure the bed is completely cleaned and don’t touch the plate after cleaning.

We recommend using an adhesion product like spray (3DLac) or hairspray (make sure it’s sticky). In some cases, using glue sticks (Elmer’s Washable School Glue) will work great too. Make sure you not to use too much of the adhesion product as this will make the adhesion to the bed worse.

 

DESK series

If you’re using the PEI bed which is default on the desktop series or you have a basic glass plate, we recommend you clean the plate with a spatula if printing remains are there.

After this, clean the plate with some Isopropanol (PEI sheet) and a towel. For a glass plate, hand warm water is sufficient. In case of some remaining grease, use some Isopropanol. Make sure the bed is completely cleaned and don’t touch the plate after cleaning.

If you’re not using our PEI sheet but a clean glass plate (without PEI sheet) we recommend using an adhesion product like spray (3DLac) or hairspray (make sure it’s sticky). In some cases using glue sticks (Elmer’s Washable School Glue) will work great too. Make sure you not to use too much of the adhesion product as this will make the adhesion to the bed worse.