knowledge and contact support tractus3d
first-time-use , setup-for-first-time-use

First time use

After installing, you need to set up the printer for the first time use. Turn on the printer with the power switch at the front, and perform the setup steps we defined in the parts below.

NOTE: Unpacking a LARGE VOLUME 3D printer should always be done by a qualified engineer of Tractus3D. Unpacking the printer on your own initiative can void the warranty.

NOTE: All the first time use steps can be found in the manual as well

NOTE: Make sure when you install the printer on the location, you will use the swivel feet to adjust the 3D printer to be level as much as possible in all directions.

 


Setup for first time use